Find your expert.
Fix your problem.
Breathe easy.
It only takes a few seconds.
Before & After Photos
Click on a photo to enlarge.
Basement Waterproofing in Rising Sun, MD
After a history of water intrusion, our team installed a perimeter of our WaterGuard drainage system along with lining the walls with our CleanSpace vapor barrier wall system. A new Super Sump pump system was connected to the WaterGuard to keep the basement dry!
Basement Waterproofing in Worton MD
Water was always getting into this customers basement and in some areas they had standing water year round. Our solution to this problem was to install a Cleanspace vapor barrier, waterguard, SuperSump Pump and a battery back up.
Damp Crawlspace Repair in Perryville, MD
This was a very tough low crawlspace with lots of dampness. We had to clean it out first and remove all the organic material. Then we installed a drainage system with a SmartSump to deal with the water issues. The floor and walls where covered with our Cleanspace Encapsulation System to keep the moisture from the ground from evaporating into the air. The result is a transformed, dry, and safe crawlspace.
Crawlspace Encapsulation in Perryville, MD
This homeowner was having issues with excess moisture in his crawlspace and wanted us to turn it into a clean, dry, energy-efficient space. Here we did an encapsulation with our CleanSpace Vapor Barrier System. We started by installing a SmartPipe Crawlspace Drain System with a SuperSump Pump System to eliminate any flooding water. We then laid down CleanSpace Drainage Matting which helps direct any water toward the perimeter drain. The old, tattered insulation was removed and replaced with SilverGlo Thermal Insulated Wall Panels, along with spray foam which we added to the rim joist area. Lastly, we wrapped the piers and walls with our CleanSpace Liner.
David Wert
This started off as a damp, moldy crawlspace. The customer was looking to remediate the mold and encapsulate the space. Here we started by removing the old insulation and cleaning the mold with our Mold X2 Cleaner and botanical solution. Next, Rim Tight Spray Foam was added to the joist area and SilverGlo thermal insulated panels were installed on the perimeter walls. We then laid down Cleanspace Drainage Matting and our Cleanspace Liner to encapsulate the space. To waterproof the area, we installed a Waterguard sub-floor drainage system along with a Supersump System which features a cast-iron Zoeller M63 sump pump, airtight lid and a floor drain. Lastly, we installed a Sanidry Sedona dehumidifier to keep the humidity low and an Ultrasump 4 battery back-up system to guard against flooding during a power outage.