Find your expert.
Fix your problem.
Breathe easy.
It only takes a few seconds.
Before & After Photos
Click on a photo to enlarge.
Concrete Lifting: Restoring a Garage Concrete Slab Back To Level in Hayward
A before and after of a concrete lifting project we did in Hayward. Polyurethane Foam was injected through the garage slab by first drilling 1/8th inch holes in a grid pattern, and then monitoring the amount of lift to ensure that we didn't go too high. After we lifted the garage slab, we then injected a joint sealant to seal the area that connects the driveway and the garage slab.
This is the right side of the garage when looking out toward the street.
Drainage in Crockett
Installed 55 ft of EZ flow piping to better assist with crawl space draining.
Push Pier Foundation System
This home, located in Campbell, was having foundation problems. They found us after doing some research on the internet. They called us and scheduled an appointment for a free home inspection (quote included). Our Structural Consultant, Steve Mack, performed the inspection. He found that the home was settling, with cracks forming and progressing on the interior and exterior stucco walls. There was some evidence of lateral movement and the floors were unlevel by about 2 inches in some areas.
Our crew installed a multitude of Push Piers to help lift and stabilize this home, to help it from future settlement.
Carbon Armor Installation and Foundation Rebar Replacement in Campbell, CA
This customer, located in Campbell, came to us with concerns about cracks in his foundation. We were able to repair the cracks by first removing the rusted rebar from within that had caused the cracks, then installing a new Fiberglass Rebar stick to replace it. Secondly, we poured new concrete to seal the area, and then sealed the deal by using epoxy and a Carbon Armor Patch (10 times stronger than steel) to make sure that this part of the foundation would crack no longer.
Foundation Crack Repair: Carbon Armor Installation in Campbell, CA
This customer, located in Campbell, came to us with concerns about cracks in his foundation. We were able to repair the cracks by first removing the rusted rebar from within that had caused the cracks, then installing a new Fiberglass Rebar stick to replace it. Secondly, we poured new concrete to seal the area, and then sealed the deal by using epoxy and a Carbon Armor Patch (10 times stronger than steel) to make sure that this part of the foundation would crack no longer.