Before & After Photos

This customer had dreams of finishing her basement to move her bedroom down there. Before starting that process she noticed some cracks in the foundation and was concerned that it could become a problem in the future. Our team came in and installed our CarbonArmor wall repair system to the bowing walls, ensuring that the walls will not move in any further. We then installed WaterGuard and CleanSpace to capture the water and remove it from the home using a sump pump. This will protect any finishing she does in the basement from water damage. 

When our team walked into this home through the front door, there was an obvious bounce in the floor. Upon investigation, the floor was being held up by telephone poles that were cut to fit but they were not strong enough to hold keep holding the home up. Also, the floor was not level. The homeowner was concerned about the bounce and the ability of the floor to withstand weight since it was not supported very well. We fixed the problem by adding SmartJacks to the crawlspace to hold up the floor. There are 2 supplemental beams that run the length of the house. We added 5 Smartjacks to the front of the home and 5 more SmartJacks to the back of the home. We also added a supplemental beam in-between the existing cinderblock supports to finish supporting the house/floor from sagging and bouncing.  

This homeowner had a block foundation wall that was bowing in and he was concerned that the wall was going  to collapse. After getting a few estimates, he knew that he needed our help and expertise to fix his bowing wall.

We sent System Design Specialist Mike Portel to inspect the bowing wall and determine what was causing this. Mike found that the soil on the outside of the block wall foundation, causing the wall foundation to fall inwards. He also noticed that there were cracks in the wall that appeared to have grown over time. Mike and the team installed PowerBraces so that the homeowner could move his foundation walls back to their position over time.

The homeowner was very happy with the quality of work and with the professionalism of the group. Check out his new PowerBrace System. 

This falling wall was looking beyond repair for this customer before our team installed EverBrace. EverBrace wall restoration system uses steel corrugated panels and beams that work together to stabilize foundation walls, adding strength and unbeatable support. Completely new look after this project was completed!

Midwest Foundation Repair recently installed SmartJack manufactured here in the USA to stabilize a sagging floor. If you are noticing sagging or bouncy floors call today for a free estimate.