Before & After Photos

A Manchester, NJ homeowner contacted Quality 1st Basement Systems after noticing a stair-step crack forming on the exterior block of their home's foundation. Our System Design Specialist, Jay A., provided a thorough inspection of the home. After, he presented his findings to the homeowner, along with a quote. A few days later, our crew arrived at the home to install the Helical Pier System. Helical Piers are designed to lift and stabilize your home's foundation. The system is below grade, so it will be easily covered after installation. Since the repair, the homeowner has not experienced any other foundation issues in their home.

A Whiting, NJ homeowner became concerned for their home after finding large gaps forming between the walls and floor on the first level of their home. They contacted Quality 1st Basement Systems to have someone inspect their crawl space to determine the cause behind their floor sagging. Our Crawl Space System Design Specialist, Anthony, performed a thorough inspection and noticed the floor joist and crawl space beams were sagging. Anthony could see that they were in good condition but lacked support and he recommended installed our SmartJack Crawl Space Support System. SmartJacks are installed against each crawl space beam to support the floor above. Gradually over time this system can bring the floor back towards its original position. 

The CarbonArmor wall reinforcement system stabilized this Jackson, NJ foundation. CarbonArmor contours to the wall, preventing the foundation from settling and cracking.

When this Jackson, NJ homeowner was told their foundation was settling, they called Quality 1st Basement Systems. The crew installed wall anchors in the basement to prevent wall cracks and further settling.

If you are experiencing large interior foundation cracks and you notice the walls are either bowing or tilting inward, then you need our PowerBrace Wall Repair solution. The PowerBrace™ system is made of steel I-beams that are secured to the joists above the wall with steel brackets. These brackets allow our Service Technicians to  easily adjustable each beam over time. The tightening of each PowerBrace will allow for a gradual pull back towards its original position.