Before & After Photos

Mold and moisture plaguing the crawlspace prompted this homeowner to give us a call. The home is 1900 square feet of crawlspace. He knew his problem would only get worse if he didn't address it immediately. With previous knowledge of our encapsulation system, he knew he was calling the right people. Ransom Ford inspected the crawlspace and found it was something we could easily rectify. 

We sealed off the vents and openings, installed a sump pump in the lowest spot, lined it with our 20 mil liner, and finally placed a dehumidifier inside the crawlspace to regulate the humidity. Now his home is moisture free and it would be impossible for mold to grow on his joists with our system. 

At a height of right over two feet, this crawlspace was holding moisture due to visqueen being put over the ground. This plastic, because it's not sealed off and air tight, ends up hurting the crawlspace more than helping it. It traps water under the plastic and creates musty smells that may not have been there before. Melissa Johnson inspected this crawlspace and proposed our well tested solution. We were able to remove the visqueen and apply our encapsulation system to the crawlspace. We do this by cleaning out the crawlspace, installing a sump pump, drainage matting, CleanSpace liner on top of the matting and sealing it off around each wall of the crawlspace, and putting a dehumidifier in on top of it. These products work together to keep moisture out and dry air in. 

We can never get enough of seeing dirt crawlspaces transformed into clean and protected areas. Here is an example from one of our customers in Yazoo City. The damp, dirt floor is now covered with out durable CleanSpace Liner. This will work in combination with our Crawlspace Dehumidifier to make sure the underside of this home stays dry and ready to combat all forms of moisture. 

Two photos taken in the same crawlspace in Yazoo City, by one of our talented teams led by Foreman Kannon! Our CleanSpace Liner makes a world of difference when it comes to fighting moisture. Not to mention aesthetics!

This customer had insulation in their crawlspace in an attempt to keep the home warm. This caused more issues than just cold floors though. The insulation attracted water, keeping the moisture close to the floors which caused mold and rotting on the floors. We removed the insulation, sprayed a mold removal, and then encapsulated the crawlspace. This corrected the cold floor issue, took care of the mold, and then created a controllable environment where rot cannot take place.